Red Line CV-2 Grease with Moly
Special order — we bring it in, then call you with timing.
Size
Shipping: AB/SK/MB $30 · ON/QC $40 · NT $50 — base rate free over $150. BC or Atlantic Canada? Ask us for a shipping quote.
Pickup in Edmonton — free. Taxes and shipping calculated at checkout.
100% genuine
100% genuine Red Line, from authorized North American distribution.
A synthetic, non-soap NLGI #2 extreme-pressure grease with moly, made for the high temperatures and loads in high-performance wheel bearings, U-joints and high-angle CV joints. It carries the NLGI GC-LB service rating, has a useful temperature range of -100 °F to 500 °F (about -73 °C to 260 °C), and resists water washout. It darkens after high-temperature use, which does not affect performance.
- Outperforms the best conventional or synthetic greases and lubes
- Withstands extreme temperature and pressure in wheel bearings, U-joints and high-angle CV Joints
- Excellent high-temp stability, extreme-pressure protection and water resistance
- Used in a variety of applications with operating temps from -100°F to 500°F
- Strong resistance to oxidation and corrosion, low evaporation and oil separation with a minimum effect on rubber seals
- Contains an organic moly for chassis lubrication and high temp/high speed industrial equipment
- Synthetic fluidity allows increases in bearing life up to 200%
- Will darken after high-temp use-not detrimental to performance
Warnings
- Warning: This product can expose you to chemicals including Quartz (14808-60-7) which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov
- Although Red Line CV-2 is compatible with small amounts of many petroleum-based greases, it is always good lubrication practice to thoroughly clean out the old grease to eliminate abrasive particles and to minimize the possibility of grease incompatibility.
- Red Line CV-2 will slightly darken after high-temperature use; this darkening will not detrimentally effect the performance of the grease.
- For health safety information, please refer to the Safety Data Sheet at REDLINEOIL.COM
Specifications & Approvals
NLGI Grade #2; NLGI Service GC-LB; Thickener Non-Soap; Fluid Type Thermally-stable synthetic; Useful Temperature Range -100°F to 500°F; Color Red; Dropping Point, >800°F; 4-Ball Wear (ASTM D-4172B) 0.46; 4-Ball Weld (ASTM D-2783) 400 Kg; Load/Wear Index (ASTM D-2783) 71.1; Water Washout @ 105°F 1%; Evaporation Loss, 22 hrs @ 350°F 4%; Oil Separation, 30 hrs @ 350°F 5%; Oxidation Stability, 500 hrs @210°F, ∆psi 1.75 (12 kPa); Rust Test, ASTM D1743 Pass
Recommended for vehicles requiring
Wheel bearings, U-joints and high-angle CV joints; High-performance wheel bearings and CV-joints; Chassis lubrication; Industrial: high-temperature alternator bearings, high-speed ball bearings, conveyor bearings, worm gear drives, servo mechanisms and applications where vibrations can cause fretting wear and corrosion